COMPRESSIVE K

Single-component

multi-cortical implant

with enlarged surface area

Widening and cutting strands of Compressive-K implant are designed in a way that creates an opportunity to additionally fixate the implant to lateral alveolar walls during the implantation. It shapes so called multi-cortical (multiple) fixation.

The surface area of an implant is especially enlarged. Compressive-K implant has 20-50 % wider surface area than classical two-piece or compressive implants of the same diameter and length. It is very important in clinical situations where large occlusal forces are observed, especially when bone structures is soft.

Deep subcrestal placement

No screw under the gum

Bendable neck for ⌀3.0/3.5/4.0/4.5 implants

Cemented, screwed or screwed-cemented prosthetics

Surface area 

Telescopic caps 

    Titanium and PEEK telescopic caps were created in order to manage the prosthetics that are fixed on the dental implants, e.g. to take them off without damaging if needed.

 

Also they allow sinking the edges of a dental prosthetic under the gum and not to worry about the residue of cement, because it can be cleaned when the prosthesis has to be taken off and after cleaning put back into the mouth. It is so called reverse conus or telescopic fixation.

 

In case you need to remove the prosthesis without cutting it, it is not necessary to make a path to screw a hole in the chewing surface of denture what is mandatory with classic implants. This method improves aesthetics in chewing surface of denture.

Sizes

D Ø 3.0 mm Ø 3.5 mm Ø 4.0 mm Ø 4.5 mm Ø 5.0 mm Ø 5.5 mm Ø 6.5 mm Ø 7.5 mm Ø 8.5 mm
L 6mm C3006 C3506 C4006 C4506 C5006 C5506 C6506 C7506 C8506
L 8mm C3008 C3508 C4008 C4508 C5008 C5508 C6508 C7508 C8508
L 10mm C3010 C3510 C4010 C4510 C5010 C5510 C6510 C7510 C8510
L 12mm C3012 C3512 C4012 C4512 C5012 C5512 C6512 C7512 C8512
L 14mm C3014 C3514 C4014 C4514 C5014 C5514 C6514 C7514 C8514
L 16mm C3016 C3516 C4016 C4516
L 18mm C3018 C3518 C4018 C4518
L 20mm C3020 C3520 C4020 C4520